Juniper-systems Allegro DOS Manual Manual de usuario descargar pdf (Pagina 93)

Allegro DOS Owner’s Manual 93

Bypassing Individual Commands

If you suspect your problems are related to a speciﬁ c command, you

can view each command individually and bypass only the command

you think may be causing the problems. To review individual

commands, follow these steps:

Reboot the Allegro by pressing the On/Off key for 8 to 10 seconds

(just until the screen clears). After the system starts, DOS displays

the following message:

Starting MS-DOS...

While the text is on your screen, quickly press and release the F8

key. One by one DOS displays each command in your CONFIG.

SYS ﬁ le followed by a prompt. To accept a command, press Y for

yes. To bypass a command, press N for No.

When DOS ﬁ nishes processing the CONFIG.SYS ﬁ le, the

following prompt appears:

Process AUTOEXEC.BAT [Y, N]?

If you also want to view the commands in your AUTOEXEC.BAT

ﬁ le, press Y for yes.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 165 166

Sin comentarios

Juniper-systems Allegro DOS Manual Manual de usuario Pagina 93